Cirrus-logic CS4207 Manual de usuario Pagina 95

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 148
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 94
DS880F4 95
CS4207
6.10.6 EAPD/BTL Enable
Get Parameter Command Format:
Set Parameter Command Format:
Get Response Format:
Bits [31:28] Bits [27:20] Bits [19:8] Bits [7:0]
CAd = X Node ID = 0Bh Verb ID = F0Ch Payload = 00h
Bits [31:28] Bits [27:20] Bits [19:8] Bits [7:0]
CAd = X Node ID = 0Bh Verb ID = 70Ch Payload = xxh
Bits Type Default Description
31:3 Read Only 0 Reserved
2 Read Only 0b
L-R Swap: Not valid since the widget is not
capable of left/right swapping.
1 Read Only 0b
EAPD: EAPD is not supported by this pin widget.
0 Read/Write 0b
BTL: controls the output configuration of a Pin
Widget which has indicated support for balanced
I/O (bit 6, Pin Capabilities Parameter). When this
bit is 0, the output drivers are configured in nor-
mal, single-ended mode; when this bit is 1, they
are configured in balanced mode.
Vista de pagina 94
1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 147 148

Comentarios a estos manuales

Sin comentarios