Cirrus-logic CDB53L30 Manual de usuario descargar pdf (Pagina 12)

12 DS963DB1

CDB53L30

4.3 Using the FlexGUI Tabs

4.3.1 Board Config Tab

The “Board Config” tab contains the controls for configuring the MCLK source, S/PDIF transmitter, serial header, and

CS53L30 mute signals. The individual functions of this tab are described below.

• Quick Setup—Drop-down box for selecting a factory preset register configuration.

• MCLK—Settings for onboard MCLK frequency and MCLK routing.

• S/PDIF Transmitter—Settings for the CS8406 S/PDIF transmitter. See Section 1.5 for more information.

• Mute Control—Configures the state of the microcontroller I/O pins which drive the CS53L30 MUTE inputs. To

enable these controls, jumper pin block J4 must have the corresponding “FlexGUI CNTL” jumpers placed.

• Serial Header Direction—Configures the SCLK and LRCK/FSYNC signal direction for the serial audio header, J29.

When configured as Master, SCLK and LRCK/FSYNC are outputs from the CDB53L30. When configured as Slave,

SCLK and LRCK/FSYNC are inputs to the CDB53L30.

• Device and Revision I.D.—Displays the CS53L30 revision information.

• Refresh—Reads all registers in all devices and updates the values in the FlexGUI.

• Reset CS53L30-1—Sends a reset pulse to CS53L30 #1.

• Reset CS53L30-2—Sends a reset pulse to CS53L30 #2.

Figure 4-4. The “Board Config” Tab

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 36 37

Sin comentarios

Cirrus-logic CDB53L30 Manual de usuario Pagina 12