Cirrus-logic CS4970x4 Manual de usuario Pagina 138

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 162
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 137
Host Activity
CS4953x4/CS4970x4 System Designer’s Guide
DS810UM6 Copyright 2013 Cirrus Logic, Inc 8-28
'81' correspond to the autodetection messages/response. For a description of autodetect messages, see
Section 7.3.7 “DSP_AUTODETECT_MSG”on page 7-4. Figure 8-21 shows the autodetect message for
silence.
8.9 Host Activity
The host carries out the following activities after a successful boot.
1. Flush the DSP message buffer by reading all outstanding messages.
2. Retrieve status information from the DSP using the DSP manager read commands set out in Table
7-5.
3. Send DSP Manager write commands to change concurrency mode if required. See examples of
write commands in Section 7.4.2.1 “Using DSP Condenser to Change/Load Firmware Modules”on
page 7-10 and in Appendix C, "Loading/Unloading Firmware Modules"
.
See the process flow for changing concurrency
1
modes in Figure 8-21.
1. Concurrency mode is the combination of firmware modules active at any one point in time.
Vista de pagina 137
1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 161 162

Comentarios a estos manuales

Sin comentarios