Cirrus-logic CRD48L10 Manual de usuario Pagina 34

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 44
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 33
1
Chapter 8
Programming MP3 FLASH
1. Configure CRD48L10 as described in CDB-MCU-DEBUG Controller User’s Manual, and launch a command
console window.
2. Within command console, CD to the CS48Lxx\apps\crd48l10-4in-4out\ board directory.
3. Run the script “program_spi_flashA.bat <filename>” where <filename> is the name of the image for the FLASH.
4. When programming is complete, the console window should read “Image validated by read/compare” as shown in
Fig. 8-1.
Figure 8-1. Programming MP3 FLASH
5. If the correct message is not displayed, power down the CRD48L10-4in4out, and check cable JP2 connection
between CDB-MCU-DEBUG Dongle and CRD48L10. Then, try again.
Note: Programming the MP3 flash erases the Master Boot image.
Vista de pagina 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Comentarios a estos manuales

Sin comentarios